Feature Processor STM32F103RC at 72Mhz Motor driver DRV8313 with short circuit overheat protection Onboard gyro and acceleration sensor MPU6050 IR LED Interface Futabaa S BUS Spektrum satellitee port 7CH PWM Sum PPM input output Each axis could connect analog joystick With I2C port could use external 6050 to replace onboard sensor 3 AUX portSpecifications Item Name Storm32 BGC 32 bit 3 axis Brushless Gimbal ControllerHardware Storm32BGCHardware Version V1 32Firmware o323bgc release v096Power supply 9 18V 3 4S Drive current Max 1 5ADimension 5 5cm M3 screw hole 45mm pitchWeight 10gHow to install 1 Remove vibration ball open at the mounting plate 2 Lock mounting plate with screws at the bottom of the craft 3 Install the shock absorber ball 4 Install the camerawith a belt style compact camera Note Install the camera be sure to install the camera properly otherwise it will shake power on the gimbal and stabilize it for above 30 seconds do not shake the gimbal keep it hanging do not touch the camera with hands keep it suspended After hearing the sound it can be used normally Package included 1 x Strom32 3 Axis gimbal controller DRV8313 Driver1 x Sensor
