DescriptionDetailsPush Cup Washer: It only requires you to press with one hand to dispense water for a quick cup rinse.Anti-overflow Hole: This design can effectively prevent the water from overflowing when you don't turn off the faucet in time.ApplicationThis product is suitable for kitchen sinks, center island counter sinks, bar sinks, flat sinks, wine counter sinks, etc.How to Install1.Place the sink in the installation position, turn it over, and place it on the floor. Press down on the sink and trace the outline along the edge of the sink.2.Remove the sink and draw a cut line 0.39 inch inside the outline of the sink.3.Drill a hole with a diameter of 14.96 inches inside the cutting line, put in the saw blade, and cut along the cutting line, then use sandpaper(not included) to smooth the cut.4.Fill the outside of the incision with clear silicone(some installers use glass glue)(not included), width 0.13-2.52in.5.After installing the kitchen faucet, put the sink close to the front edge and ease it down.6.Check the position of the sink on the countertop again, apply glass adhesive(not included) or install the fastener at the connecting strip, and clean the countertop.SpecificationMaterial: Nano-stainless steelColor: BlackProcess: Spray FinishingShape: RectangularStyle: ModernAssembly Required: YesMounting Type: Under-counter, Center, CountertopSink Depth: 220mm/8.66inProduct Size: 54.86*44.96*22.1cm/21.6*17.7*8.7inPackage Size: 60*50*26.5cm/23.62*19.69*10.43inGross Weight: 8.6kg/18.96lbsNet Weight: 7.3kg/16.09lbsPackage Included1* Bar Sink1* FaucetOther Accessories for AssemblyNotes1.Please check the size carefully before ordering.2.Please note that if you carry out the under-counter basin installation, you need to take the cover and sink together to the qualified installation person, in order to open and install the holes together against each other, to avoid the situation that the cover can not be covered.Stainless Steel
