Hobbywing S BUS2 5 9V Telemetry Adapter Data Transmission Module For Futaba Air ESC RC Airplane CarProduct Introduction This adapter is suitable for Platinum V4 4 1 5 series with data backhaul function The electronic governor is connected to the Futaba receiver that supports the S BUS2 protocol enabling the ESC to transmit Telemetry data to the Futaba Radio in real time displaying the functions Instruction Manual 1 Use a cable to connect to the ESC port usually identified as P and the adapter P side 2 Connect the adapter S BUS2 to the Futaba receiver to identify the channel of S BUS2 3 Connect the ESC throttle signal line to the Futaba receiver throttle channel Note The input voltage is 5 9V The P port does not provide a power input Parameter setting method 1 According to the image above connect the adapter and LCD program box adapter P side connection LCD program box ESC side adapter S BUS2 cable using Y wire to connect to the program box to set the power supply at the end of the box with the battery the battery is recommended to use 2S battery 2 Press the OK key upon connecting the program box After the connection is successful the current firmware version number will be displayed 3 After adjusting the parameters on interface press the ITEM key to browse the parameter item press the VALUE key to change the parameter item s set value 4 Once after the setting value has been changed press the OK key to save the setting
