Bolt Down Fencing Post Shoe - Quick Fit - Oxide Red

Bolt-Down Post Shoe (Quick-Fit, Oxide Red) provides a fast, reliable way to secure timber posts to existing concrete, brick or timber bases—without digging or casting new footings. The quick-fit clamping design locks the post in place with minimal tools, while the wide bolt-down base spreads load for a rigid, above-ground installation that helps protect post ends from moisture. Key Features & Benefits Quick-Fit Clamping: Fast to position and tighten for a secure, twist-resistant hold. Bolt-Down Base: Pre-drilled plate fixes to concrete, brick or timber substrates. Protects Timber Ends: Raises posts off the ground to reduce rot risk. Durable Finish: Oxide red coating for corrosion resistance and a clean appearance. No-Dig Solution: Ideal where excavation would damage paving or services. Product & Technical Details Type: Bolt-down post shoe (quick-fit clamp) Material: Heavy-gauge steel Finish: Oxide red coating Fixing to Substrate: Anchor bolts/screws through base plate (not included) Typical Applications: Fencing, pergolas, carports, handrails, decking balustrades Instructions for Use Mark out and drill the substrate for suitable anchors; clear dust from holes. Bolt the shoe down firmly and verify plate sits flat and level. Insert the timber post fully; square and plumb it, then tighten the quick-fit clamp evenly. Re-check alignment and re-tighten after initial settling; inspect periodically in service. Limitations & Precautions Select anchors and shoe size to suit loads; seek structural guidance for high uplift or lateral loads. Use corrosion-appropriate anchors; increase inspection in coastal/aggressive environments. Cut post ends square and treat end grain with preservative prior to clamping. A rapid, no-dig bolt-down solution that clamps posts securely and keeps timber clear of standing water—ideal for strong, tidy installations on existing slabs, brickwork and decks.